Soldering

1213-0090-P1 Package of 1 This is used to hold the tip into the handpiece to make sure that the electrical connections in the TD 100/ TD 100A &a...

POWER MODULE HEAT LEVEL 8.5 FOR ST70 (SILVER) In New Zealand Baskiville are authorised agents for Pace Baskiville stock and support Pace produ...

Front Seal, Heater For PACE SX70 and earlier In New Zealand Baskiville are authorised agents for Pace Baskiville stock and support Pace produ...

ST 70 Power Module - Heat Level 7.5 (Violet) Power Module - Heat Level 7.5 (Violet) In New Zealand Baskiville are authorised agents for Pace ...

POWER MODULE HEAT LEVEL 5.5 FOR ST70 (TURQUOISE) In New Zealand Baskiville are authorised agents for Pace Baskiville stock and support Pace pro...

Variety of Track sizes and shapes for board repair

ThermoBond SOICs, TSOPs Frame Only Small, low cost frames provide you with the selection you need without wasting material.

NON THERMOBOND CIR KITS FRAMES Track and Pad Variety

The PACE 1205-0014-P100 Pin Connector Terminals are precision-cut electrical connectors designed to ensure reliable connections in soldering, desol...

Track repair for DIP s

Different Track sizes for Repairs Small, low cost frames provide you with the selection you need without wasting material

Packet of 100

Pace Terminal Bifurcated Solder terminal, thru hole, forked, .116 (2,95) mounting hole (#32 drill). Packet of 100

The Pace 1192-0030-P1 Transformer is a genuine replacement part engineered to deliver stable and isolated power for Pace soldering and desoldering ...

To fit Quick 206D soldering iron

For Pace SX300E 24 volt Relay

The Pace 1179-0133-P1 Voltage Control AC V MBT is a precision AC voltage control module designed for MBT soldering and desoldering systems. It ensu...

The Pace 1159-0011-P1 Fuse is a precision-engineered protective component rated at 1 Amp. Designed to safeguard electronic assemblies, it interrupt...

Power Switch, Rocker Power switch for all Pace ST Stations

Replacement transformer for Pace soldering and rework systems, providing stable, isolated power for reliable performance.

DIALIGHT 559-2101-005

The Pace Fuse S.B. 3 Amp (1159-0001-P1) is a precision slow-blow fuse designed to protect Pace equipment from overcurrent damage. It allows short c...

The Pace 1140-0036-P1 Port, Test, Vacuum is a genuine replacement and service component designed for Pace desoldering and rework systems. This vacu...

The Pin in the front of the picture is P/N 1132-0017 and goes into the base P/N 1321-0054 and can be ordered separately. Both are needed to make ...