Monitors, Testers & Calibration

The Desco Mini Monitor is a single workstationcontinuous monitor. It continuously monitors the path-to-ground integrity of one operator and one ESD worksurface. The Mini Monitor eliminates the need for periodic testing and record keeping of wrist straps.

Single Workstation Continuous Monitor with Universal Power Adapter
Continuously monitors the path-to-ground integrity of one operator and one ESD worksurface

IMPROVED Operator Alarm
Alarms when the operator unintentionally disconnects from the monitor or the connection between the banana plug and monitor’s jack is intermittent

Desco Wave Distortion Technology
Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap’s path-to-ground* and the presence of its 1 megohm safety resistor

Park Snap
Allows the operator to disconnect (and park) a wrist strap when leaving the workstation without creating a false alarm

Single-Wire Impedance Design
Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0

Continuous Visual and Audible Alarms
Illuminates green to indicate proper grounding; illuminates red and sounds audible alarm when intermittent or failed connection occurs

Calibration Verification
Use the Desco 98221 Monitor Calibration Unit to check the test limits of Wave Distortion Monitors without removing them from their workstations

NIST Calibrated with Certificate Included
Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology. For more information on the calibration of Desco products, see Calibration.

100-240VAC Power Adapter with IEC C14 Style Inlet
Connects to a power cord with a IEC C13 outlet connector

Made in the United States of America

*The ESDA Wrist Strap standard is ANSI/ESD S1.1. The Wrist Strap System required limit per ANSI/ESD S20.20 Table 3 is 0.8 to 1.2 x 106 ohms with product qualification testing per ANSI/ESD S1.1. The test range of the monitored circuit is 500 kilohms to 10 megohms.

1.2 Volt Operator Test Voltage
Reduces the risk of electrical overstress (EOS) for the handling of sensitive components

<50 Millisecond Alarm Response Time
Identifies failures and intermittencies that inferior technologies miss

1 Mini Monitor
2 Countersunk Washers
2 Flat Head Screw, 6-32 x 1/4"
1 10mm Interchangeable Park Snap
1 10mm Operator Jack Adapter
1 Power Adapter, 24VDC, IEC Inlet
1 Certificate of Calibration

DES19243 TDS